栏目列表
新闻动态 当前位置:首页>新闻动态>新闻动态

超声波清洗机使用事项

网址:www.com-to-com.com  2020-07-24  作者:admin    阅读:

超声波清洗机使用事项:
Use of ultrasonic cleaning machine:
⑴ 超声波清洗机电源及加热器电源必须有良好接地装置。
(1) the power supply of ultrasonic cleaning machine and heater must be well grounded.
⑵ 超声波清洗机严禁无清洗液开机,即清洗缸没有加一定数量的清洗液,不得开超声波开关。
(2) it is forbidden to start up the ultrasonic cleaning machine without cleaning fluid, that is, the cleaning cylinder is not added with a certain amount of cleaning fluid, and the ultrasonic switch is not allowed.
⑶ 有加热设备的清洗设备严禁无液时打开加热开关。
(3) it is forbidden to turn on the heating switch when there is no liquid in the cleaning equipment with heating equipment.
⑷ 禁止用重物(铁件)撞击清洗缸缸底,以免能量转换器晶片受损。
(4) it is forbidden to strike the bottom of the cleaning cylinder with heavy objects (iron parts) to avoid damage to the energy converter wafers.
⑸ 超声波发生器电源应单独使用一路220V/50Hz电源并配装2000W以上稳压器。
(5) the power supply of ultrasonic generator should use a single circuit of 220 V / 50 Hz power supply, and be equipped with a voltage regulator above 2000 W.
⑹ 清洗缸缸底要定期冲洗,不得有过多的杂物或污垢。
(6) the bottom of the cleaning cylinder should be washed regularly, and there should be no excessive debris or dirt.
⑺ 每次换新液时,待超声波起动后,方可洗件。
(7) when changing the liquid, the parts can be washed only after the ultrasonic wave is started.

返回新闻

联系电话
17073244888